Cablecast Manual

Crawl Schedule

The Schedule can be switched to viewing crawls by clicking the button in the Schedule Toolbar. The fields of a crawl event are described from left to right below.

FieldDescription
CheckboxIndicates if the crawl event is selected. Selected crawl events can be deleted or copied as a single block using the Schedule Toolbar.
StartThe time that the crawl event will begin to display.
TextThe message that will be displayed by the crawl event.
LengthThe duration in hours:minutes:seconds that the crawl event will be displayed.
EndThe time that the crawl event will stop being displayed. Calculated by adding the to the properties.
ActionsThe delete button, can be used to delete an individual crawl. The edit button will open the side pane.

Creating Crawls

Creating a new crawl is easy.

  1. Navigate to the desired date for the new crawl event.
  2. Click in the or in the right side pane to bring up the pane
  3. Fill out and fields.
  4. Click to save the new crawl event.

Editing Crawls

To edit an existing crawl, click the edit button, in the section of the crawl event you wish to edit. This will open the same form described in Creating New Crawls. Make the desired changes and click to finish the edit.

Deleting Crawls

Deleting crawl events is the same as deleting runs described in [Deleting Runs](#sec: UiReference: Schedule: ShowsSchedule: DeletingRuns).

  • Single Crawl Event: To delete a single crawl event, click the delete button, in the section of the crawl event you wish to delete.
  • Multiple Crawl Events: To delete multiple crawl events, click the checkbox of each crawl event you wish to delete adding it to the current selection. Then, click in the .