Thank you for purchasing a VIO server from Cablecast Community Media! This guide will walk you through setting up your new server.
Before beginning the installation, please make sure that you have the following resources available:
• An ethernet network connection
• A keyboard, mouse, and a VGA monitor
• Your existing A/V infrastructure (At least one video monitor, if you’re just testing)
Overview of Setup
There are three parts to setting up your Cablecast server: Physical Setup, Software Setup, and Testing.
Physical Setup : You’ll learn about the physical connections on the Cablecast server, and how to tie it into your existing infrastructure.
Software Setup : You will be taken through the steps necessary to configure the Cablecast software to communicate with your server.
Testing : Finally you’ll run some simple tests to make sure the Cablecast server is correctly configured and ready to use.
Sound like a plan? Let’s get started!
Part I: Physical Setup
Your Cablecast server should come with the following items in the box:
AC power cables : Powers the Cablecast server.
Server : The Cablecast server itself.
On the back of your Cablecast server, you’ll see several ports. Please refer to the diagram below for connections on your VIO Lite server.
All of the Cablecast servers share some basic system connections:
1. Connect a keyboard and mouse via the USB ports.
2. Connect a monitor. The monitor is required for server setup, and we recommend that it remain connected. All Cablecast servers have at least a VGA
port, and this is what we recommend connecting up to the KVM in your rack.
3. Connect the Cablecast server to the network via one of the ethernet network
4. Connect the Cablecast server’s power supply to an AC power source using
the provided AC power cables.
Next, you will connect the Cablecast VIO2 server to your video infrastructure.
The VIO2 ships in a 1x1 configuration (one input and one output) from the factory. It can be reconfigured between 1x1 and 0x2 (zero inputs and two outputs) using the VIO IO Configuration Utility as covered later in this article.
1. Connect a cable from BNC 1 to an input on your SD/HD-SDI routing switcher.
2. Connect a cable from BNC 2 to an input or output on your SD/HD-SDI routing switcher, based on your needs. Ex. in 1x1 mode BNC 2 would be your encoder and fed from an output on your routing switcher.
3. Connect house tri-level or analog blackburst to REF BNC (far left in picture).
FIGURE 1: The Cablecast VIO2
1. AC Power
2. RS232 COM port (male)
3. USB 2.0
4. USB 3.0
7. Ref In
8. Out 1
9. In 1 (or Out 2 when configured as 0x2)
Once your Cablecast server is connected, power on the server by pressing the power button on the front of the unit. The unit will boot and go through Windows System Preparation steps. You will need to create a Windows user/pass, and once into Windows be ready for both IO configuration (if needed) and Cablecast software setup.
Figure 2 VIO IO Configuration Utility
Details coming soon. For now, changing VIO IO configuration is something Cablecast member will need to do during commissioning.